admin

January 22, 2021

SMR Gearbox Installation
Satisfactory effectiveness depends upon proper set up. lubrication and upkeep. for that reason it is crucial that the directions from the set up and upkeep leaflet. provided with each gearbox. are followed carefully. a number of the vital aspects of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as close for the reducer probable, and mount reducer on driven shaft as near to bearing as sensible. failure to perform this will likely lead to extra loads from the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive together with the belt pull at approximately 90° for the center line involving driven and input shafts. this will likely allow tensioning of the wedge belt drive with all the torque arm which must preferably be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the appropriate.
3. lnstall torque-arm fulcrum on a rigid support to ensure the torque-arm might be at about appropriate angles on the center line through the driven shaft along with the torque arm situation bolt. make sure there is certainly enough get up while in the turnbuckle for belt stress adjustment.
Hold close.
Bell drive could possibly be located in any convenient postion. if your torque arm is usually to be made use of to tighten the belts, the drive really should be at about tight angle on the line concerning the input and output shafts.
Bell drive may be positioned on the proper if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite direction to that shown during the illustration.
Torque arm and belt consider up.
Torque arm may very well be mounted for the suitable if sought after.