Observing a handful of guidelines for proper installation is crucial to your trusted and correct operation with the gearbox or gear motor.
The rules set out listed below are intended like a preliminary guide to picking gearbox or gear motor. For productive and suitable set up, comply with the instructions provided during the installation, use the maintenances manual to the gearbox out there from our sales department.
Following is really a quick outline of set up rules:
a) Fastening:
Place gearbox on the surface giving sufficient rigidity. Mating surfaces needs to be machined and flat.
Mating surfaces should be inside of definite geometric tolerances (see guide). This is certainly in particular genuine of flange-mounted gearboxes with splined hollow shafts.
In applications that involve large radial loads on the output finish, flange mounting is recommended for some gearbox sizes as this mounting helps make utilization of the double pilot diameters presented in these gearboxes.
Ensure that the gearbox is ideal to the required mounting place.
Use screws of resistance class 8.8 and in excess of to safe the gearbox. Torque up screws to the figures
indicated during the pertinent tables.
With transmitted output torque better than or equal 70% from the indicated M2max torque, and with
regular motion reversals, use screws with minimal resistance ten.9.
Some gearbox sizes can be fastened utilizing both screws or pins. Of pin seated in the frame the gearboxes be at the very least 1.five instances pin diameter.
b) Connections
Secure the connection elements to gearbox input and output. Will not tap them with hammers or related tools.
To insert these elements, make use of the service screws and threaded holes supplied within the shafts. Make sure you clean off any grease or protects from your shafts in advance of fitting any connection elements.
Fitting hydraulic motors.
Be careful the O ring among motor flange and gearbox input flange when assembling. Set up the
hydraulic motor in advance of filling lube oil in to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit ought to be this kind of to ensure that brake is released instants ahead of gearbox commences and utilized following gearbox has stopped. Check that pressure in the hydraulic line for brake release is at zero whenever gearbox is stopped.
Course of rotation
Motors are linked to your appropriate electrical or hydraulic circuit in line with their direction of rotation.
When performing these connections, bear in mind that all gearboxes, irrespective of whether inside the in-line or right angle layout, have the exact same course of rotation each at input and output. For much more details from the connection of electric and hydraulic motors, see relevant sections in this catalogue.